How to configure a Netcomm Wireless NF18ACV/NF10WV router to accept IPv6

Configuring a Netcomm Wireless NF18ACV/NF10WV router to accept IPv6 on the Pentanet network is quick and easy. Here’s how:

Before you begin

The Netcomm Wireless NF18ACV/NF10WV router will need to be configured and online.

You might also want to read our article All About IPv6.

Configuring your Netcomm Wireless NF18ACV/NF10WV router to accept IPv6

First connect to your router via Ethernet or WiFi and browse to http://192.168.20.1

New Firmware (NC2):

Old Firmware (NC)

Still stuck?

Each of the devices on your network should now receive an IPv6 address in addition to the IPv4 address they already receive, if some of your devices don’t receive an IPv6 address first try turning them off and back on. If they still have not received an IPv6 address please reach out the the manufacturer of the device as there may be additional steps to enable IPv6 for the device.

When connecting to a Netcomm Wireless router for the first time some windows devices won’t receive an IPv6 address. If this happens to you you’ll need to disable and re-enable IPv6 on your windows device.

If you’ve followed the steps above and are still stuck, please reach out to support for assistance.

Was this FAQ helpful?
FAQ details:
Published date: 09/08/2019
Last updated: 09/08/2019 (Daniel)
^ Top of Page